PTM-GP RUBBER MOUNT ISOLATOR

TOZEN Model PTM-GP vibration isolator are one-piece mounted neoprene with one cast-in load transfer steel plate at the top and base-plate at the bottom. The rubber is loaded in both shear and compression to provide the desirable straight line rubber-in-shear deflection curves as well as overload protection. The rubber-ribbed baseplate provides skid resistance and need not be bolted to the floor on most installations. The standard neoprene rubber is oil resistant and had been designed to operate within the strain limits of the isolator to provide the maximum isolation and longest expectancy.

Model PTM-GP is available in 9 sizes with load capacity from 30 Kgs to 450 Kgs. Standard static deflection of PTM-GP is 8-10mm.

TOZEN PTM-GP rubber floor mounted can be used to isolate noise and high frequency vibration generated by mechanical equipment’s located on a grade supported structural slab or pier. Model PTM-GP is recommended for the isolation of vibration produced by small pumps, vent sets, low pressure packaged air handling units, etc., and usually selected when first cost must be minimized.

Vibration isolators shall be moulded from neoprene or oil resistant synthetic rubber. Rubber isolator shall incorporated with a cast-in-top steel load transfer plate in the load surface for bolting to the supported equipment and skid resistant baseplate with holes provided for anchoring to supporting structure.

Body – Neoprene rubber
Inserts – Mild Steel

MODEL	RATED CAPACITY		MARKING LOAD	DURAMETER	FREE HEIGHT	A	B	C	D	E	F	Bolt
	(kgs)	(Lbs)
PTM-GP-30	30	66	30	40	35	40	84	60	8X13	5	30	M8X25
PTM-GP-50	50	110	50	50
PTM-GP-75	75	165	75	60
PTM-GP-100	100	220	100	40	50	0	104	80	9X16	6	45	M10X25
PTM-GP-150	150	330	150	50
PTM-GP-200	200	440	200	60

 

Note: The contents of this catalogue are subject to change without notice.